Transfer tokens on Ethereum Virtual Machine

1·Take

Take opens by declaring token as a caller parameter, naming the asset this run reads and sends at execution time.

2·Get token balance

Using that token, the balance held by Your Wallet is read, capturing the holding on hand before any transfer.

3·Bubble

Surfacing that measured balance as an output of this plug hands the pre-transfer holding back to the caller.

4·Get token balance

Reading the token balance held by Your Wallet a second time captures the holding at this point in the flow.

5·Bubble

That second balance reading is surfaced as an output of this plug, returning the figure to the caller.

6·Take

Next, amount is declared as a caller parameter, sizing how much of the token the transfer moves.

7·Take

Following that, recipient is declared as a caller parameter, naming the address that receives the token.

8·Take

Also taken is frequency, a caller parameter supplying the interval the rate limit below uses.

9·Repeat

Capping cadence, this rate limit permits at most one run every frequency, so the schedule advances no more than once per that interval.

10·Transfer tokens

On each run, amount of the token is transferred to recipient, sending the asset from the socket to that address.